Reason #1: The iMRS uses proven Earth-based frequencies

The Earth-based 0-50 Hz. frequency range is also the most proven frequency range based on research. The Schumann Resonance, with harmonics, is roughly 7.83 Hz up to 45 Hz. The geomagnetic frequencies start in the very low sub-hertz, and then tie in very nicely up to the Schumann Resonance.

The iMRS is one of the few full-body mat PEMF device that primarily uses the frequencies of the Earth. These 0-50 Hz frequencies are the frequencies that the Schumann resonance in the Earth, and the higher harmonics of Schumann, are the frequencies that our tissues and cells respond to. And these are actually the frequencies that we project, according to Zimmerman and Sato’s studies in Japan. And also it’s very common knowledge that our brain state from low Delta to high Beta goes from 0-30 Hz. That’s just standard, medical knowledge. So the #1 reason is that the iMRS uses exclusively Earth-based frequencies.

The iMRS with the four settings goes all the way to cover the entire spectrum of Earth-based frequencies. It’s not only the most natural, but it’s the most research-proven. Here is a frequent question we get:

Does the iMRS cover 0-30 Hz (and beyond) even though the listed frequencies are 0.5 (night), 3 (evening), 5.5 (noon) and 15Hz (morning)? The chart shown demonstrates that this frequency range is not only the most natural, but has the most research to back it up.

But YES! The iMRS covers this range very nicely.
The iMRS does go higher frequencies due to the harmonics of the pure tightly wound copper coils and the nature of electromagnetic waves (and anything that gives a pure vibration (tuning forks etc.). Plus the sawtooth waveform has many more bundles of frequencies embedded within the signal itself.

Frequency Resonances and Harmonics

Carrier Frequencies in full-body mat are 0.5, 3.0, 5.5 and 15Hz.
A fundamental principle of physics is that each frequency transmitted has higher harmonics (as do musical instruments and tuning forks).
So to spell it out
0.5 NIGHT —-> 0.5, 1.0, 1.5, 2.0, 2.5, 3.0 , etc.
3.0 EVENING —> 3, 6, 9, 12, etc.
5.5 NOON —-> 5.5, 11, 16.5, 22, etc.
15 MORNING —-> 15, 30, 45, 60, etc.

So with these harmonics, the iMRS covers 0-50 Hz. And because of the nice sawtooth on full-body mat and the tightly wound pure copper coils, you get a wide range of harmonics easily covering 0-50 Hz which is the most important range. What this means is ALL the frequencies are covered in Every session. This makes it much easier and more effective than systems where you can or need to program in specific frequencies.

Further Evidence and Research in the 0-50 Hz Range
Notice Many conditions ABOVE 50 Hz are also listed below 50 Hz (Eg. Osteogenesis, DNA Synthesis)
Still all of these are considered Extremely Low Frequency (ELFs). So there is plenty of Research to Show that Lower Frequencies is what our cells, tissues and body resonate to.

Reason #2: The iMRS has a built-in circadian rhythm clock

Not only do you need a PEMF therapy device to give you the right frequency range, but you also need a built-in circadian rhythm clock to give you the RIGHT frequency for the time of day. The iMRS build-in circadian rhythm clock helps you get the right frequency for the right time of day. It’s really straightforward and simple. Between low delta and high beta, the brain operates in the same frequency ranges as the Earth-based frequencies. The iMRS gives you beta frequencies in the morning to energize you. And in the evening you get the relaxing delta and theta frequencies. For example, in the morning you’re getting primarily around 15 Hz, which is a healthy Beta brain-state frequency. This helps to wake you up and energize you so you can be more alert in the morning and early part of the day (to get work done and to be mentally sharp and alert. In the evening programs it uses primarily more of the Delta/Theta frequencies (.5 Hz and 3Hz respectively), which helps you to wind down, relax and get ready for sleep. So, it’s very in tune with your biorhythm, and what you need for the time of day.​

Reason #3: The iMRS has a perfect range of intensities

The iMRS uses safe yet strong-enough intensities. The iMRS has an ideal range from the nano-Tesla, for the people who are really sensitive, up to even 300 micro-Tesla on the probe applicator. So it’s great for both sensitive people, and for localized pain relief that needs a little higher intensity.

The iMRS goes really low, down to nano-tesla. This is important for people who are chemically sensitive. Even the research on certain conditions shows that the really low intensities seem to work better. We have talked a lot about the ideal frequency range for the body being in the of 0-30 Hz range (Adey Window), but there is also an intensity window that the body ideally responds. Within the cells, if the intensity is too weak, there is no effect, if the intensity is too strong it can be harmful. 

And the iMRS goes up high enough to get through the body and a few feet above. The iMRS full body mat goes up to 70 micro-tesla, and the applicators go up to 300 micro-Tesla for localized pain relief. As we’ve discussed before, more is not better. Frequency resonance is the key. The iMRS field extends several feet above the full body mat. This intensity range along with the frequencies has been proven to be safest by the DIN, ICNRP, and other leading agencies around the world. 

The graph above gives a visual of the range of both intensity and frequency plotted vs positive physiological effect. If either the frequency or amplitude is outside this window, the body and cells do not respond favorably.

Research by Adey and Bawin, and Sisken and Walker; along with the NASA study and others have shown that low intensity (within the earth range – 33 to 66 micro-tesla), works best and it is the safest. Our cells are so sensitive they can pick up signals even in the picotesla range (100,000 times weaker than the earth magnetic field). Some PEMF devices on the market have intensities that are way too high. The key is frequency resonance, not intensity. So look for a device that uses intensities close to what the earth provides. 

Remember, “small is powerful”, and “less is more”… The key is Frequency and Resonance, not a higher intensity! The iMRS is the whole body mat PEMF device that meets these requirements (because it uses frequencies and intensities that are in alignment with the EARTH).​

Reason #4: The iMRS uses proven waveforms

The sawtooth waveform is probably one of the best-researched waveforms along with the square wave. The research goes all the way back to the 1970’s with Dr. Bassett and all the original research on PEMF. Dr Bassett observed that a rapid rise and fall time induces the maximum current in a treated tissue as with the sawtooth. In his research it was the piezoelectric current induced which accelerated bone healing. As a result of Bassett’s work, this waveform has been FDA approved in the USA for the treatment of non-union fractures and to aid in spinal fusion operations.

The reason that it works so well is that you get bundles of frequencies and amplitudes that resonate with different tissues and cells. You’re getting all the right frequencies and amplitudes. Different tissues respond to different frequencies. Rapid rise and fall are the best for improving voltage potential and energization of the cells. A sawtooth waveform provides the maximum impulse or action potential across the cell membrane, which will boost the voltage of the cell (to improve the sodium-potassium pump and recharge the TMP).

***Liboff AR. Signal Shapes in Electromagnetic Therapies: A Primer. Bioelectromagnetic Medicine. 2004, Rosch PJ and Markov MS, editors, page 32.

Reason #5: The iMRS uses a squarewave

The squarewave has a rapid rise and fall. Together with the sawtooth it’s one of the most researched waveforms. The most notable study on the squarewave is the study done by Dr. Goodwin with NASA. He found that a 10 Hz, low frequency, low intensity squarewave was the most effective waveform for healing and regeneration. In fact, they found that lower intensity worked better than higher intensity, and the lower frequencies worked better than the higher frequencies. And the rapid rise and fall saw tooth and square wave worked better than a sine wave or the more simplistic waveforms that don’t have a rapid rise and fall.

NASA STUDY
When it comes to research studies, it does not get any better than NASA. Of more than 10,000 research papers and 2000 plus double blind studies on PEMF therapy; none was more thorough and conclusive as the 4 year NASA study lead by Dr. Thomas Goodwin, PhD, on the ability of PEMF to improve the growth and repair of tissues in mammals. 

Link To NASA Study http://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/20030075722.pdf

Reason #6: The iMRS uses pure copper coils

Tightly wound pure copper coils give you the purest signals. Think of these coils as speakers, giving you the highest-fidelity signal. You also get better higher harmonics. The iMRS covers the full range of the Earth’s frequencies with a clean, pure signal.

Reason #7: The iMRS full body mat uses a graduated intensity

Graduated intensities help the body absorb magnetic fields that mimic natural fields. The head and the neck and the torso are more sensitive than the legs and extremities, and the full body mat takes these differences into account with graduated intensities.

This is very important because the legs and feet can handle a much higher intensity than the head and neck (which are the most sensitive area). When walking on the earth the feet naturally experience a slightly higher intensity, especially when in contact with the ground. But even more important for people that are chemically sensitive or electrosensitive is that the head and neck/thyroid can be easily over-stimulated and irritated. ​

Reason #8: The iMRS has the best local applicators

Dissected several PEMF devices and looked inside. It’s obvious when you see the tightly wound pure copper of the iMRS that it’s the best quality. It provides the strongest and most effective magnetic flux. That’s important for localized pain relief.

Reason #9: The iMRS has Interactive HRV (Heart Rate Variability) Biofeedback

This is one the biggest distinguishing features between the iMRS and anything else that’s out there. The iMORE system contains a photoplethysmographic sensor and specific software evaluating the heart rate variability (HRV) of the user and automatically adjusts the full body mat intensity based on what your body needs. It takes all the guesswork out of which intensity to use. The biofeedback automatically adjusts the intensities based on what your body needs. It uses a heart rate variability algorithm that is a feature that only the iMRS offers.

This puts the iMRS on “auto-pilot” because it automatically adjusts the intensity of the unit based on a heart rate variability biofeedback. It also gives you a unique session every time you use it, further preventing habituation or acclimation to the unit. That definitely happens with the sine wave and simple magnetic mattress products. You just don’t get the same benefit over time that you would initially.

Reason #10: The iMRS has an Integrated Light and Sound system

The iMRS is the worlds only stationary PEMF system, which simultaneously allows pulsed magnetic field application AND brainwave entrainment. This is a brain entrainment system is like a spa for the brain that uses frequencies that are in alignment with the full body mat. The iSLRS help to synchronize both hemispheres of the brain for increased relaxation, creativity and overall health while the full body mat recharges and energizes the body. It may help to improve your creativity and intelligence.

Reason #11: The iMRS has 284 Preprogrammed Conditions in the iGuide

This is based on 10 years of research. This further takes the guesswork out of which intensities to use and how long to do each session. You have 284 conditions programmed into your unit that covers most everything. The iGuide is useful for the pillow pad and local applicators. This helps practitioners (and customers) to get the exact settings they need for most common health conditions. So all the research-proven protocols are at the tip of your finger.

 

Reason #12: The iMRS switches polarity to reduce Habituation and Acclimation

The switching of polarity every two minutes helps to reduce habituation and acclimation. The iMRS reverses polarity every two minutes. This is important because your body will acclimate or become adjusted to a signal. What this means is that the benefits you get with the iMRS will not decrease or wane over time. There is no need to take time off with the iMRS or cycle it like 5 days on, two off, etc. The biofeedback and triple sawtooth waveform also help to reduce habituation. Of all the units on the market, the iMRS offers the most variation and the most flexibility, so it’s the one that you’re least likely to get habituated to.

You have probably heard this with drugs, supplements, exercise, etc. If you do the same thing over and over, you plateau and eventually start to decline. That’s because your body acclimates or habituates to a set supplement or routine.

But most significantly, the iMRS advanced Biofeedback system adjusts the intensity in the mat every two minutes to maximize HRV, which gives your body a unique session each time (and graphs this for you to look at after your session). For those reasons, the iMRS will give you better, safer & more effective long term results over time with no diminishing returns even if you use it every day.

Reason #13: The iMRS plug filters out Electro-Smog

The plug filters out the 60 Hz AC signal at the wall. You get a clean DC signal going into the unit that is then modulated into the Earth-based frequencies.

Reason #14: You get the best Training and Support

We personally training people and share everything on energy medicine with you.

Reason #15: The iMRS is produced by an Established Company

The company, Swiss Bionic has been around since 1996, and the unit itself has been through five generations and is continuing to evolve. The iMRS is probably one of the oldest and most proven PEMF systems. And it has a three-year warranty so you know you’ll always get support down the road.

Reason #16: The iMRS is Fully Compliant

It has FDA registration, Health Canada approval, and many leading safety and quality certificates.

The iMRS system fulfills all legal requirements in regards to product safety, product usability and is officially certified as a medical device in Europe, USA and Canada.

The iMRS has leading safety and quality certificates, including but not limited to ISO 9001, ISO 13485, EEC 93/42 certification, CE/CB product safety certificates, and ISO 14791 risk management, among others. So it’s very well accredited.

This means the iMRS has quality proven by third-party government agencies, so you know you’re getting the best quality device.

Reason #17: Research and Validation

The iMRS has some of the best research and validation of any PEMF device. 

  • Over 100 Video Testimonials
  • Over 1000 Written Testimonials including hundreds of Clinical Case Studies
  • Whole Book based on 10 years of Clinical Data in a Clinical Setting with HUNDREDS of clinical Case Studies.
  • 4 Published Research Studies
  • Dozens of Live Blood before and After
  • Infrared Thermography Studies
  • EIS studies
  • GDV Studies
  • Research Done By Psy-Tek Institute
  • Featured In the American Chiropractor

Contact us anytime, we are just a Phone Call away to assist you! Or simply just WhatsApp us now.